FLUE-GAS SAMPLE CONDITIONER

Click for Purchase Information
Flue Gas Sample Conditioner

Moisture Removal for Comprehensive and Accurate Measurements

Since NO2 and SO2 are absorbed by water, effective moisture removal from the flue-gas sample is of primary importance when obtaining accurate and comprehensive data, especially for emissions testing.

Used in conjunction with the ECA 450, the Flue-Gas Sample Conditioning System functions to remove water vapor from the flue-gas sample, thus preventing the formation of water droplets inside the probe hose. If water droplets were to form, a portion of the gas sample could be absorbed by the water, thus resulting in lower-than-actual NO2 and SO2 readings.

Water vapor is removed by passing the gas sample through a Peltier Cooler where the sample is chilled, causing the water vapor to condense. The water is then pumped out of the cooler and into a water trap.

Features & Benefits

  • Compact conditioner/probe assembly design
  • Peltier cooler to remove water from sample
  • Built-in filter section
  • Condensate pump
  • 12" probe tube length with probe stop cone (standard)
  • 15’ hose length with sample draft & temperature lines
  • Maximum operating temperature of 1472°F (800 °C)
  • Optional probe tube lengths available, up to 39"

Ordering Information

Part NumberDescription
24-7224Compact sample conditioner/probe assembly. Includes Peltier chiller/probe assembly, built-in filter, condensate pump, and 15 ft hose assembly
24-11837" (180 mm) Optional Probe Tube
24-118519.5" (500 mm) Optional Probe Tube
24-118639" (1000 mm) Optional Probe Tube